problem in print
Posted: Fri Aug 11, 2017 3:04 pm
Hi guys
I just finish to update my m2 printer to hotend v4 and installed the metal holder for the extrude motor . and after long time ( I have to wait for parts to come ) i try to print a simple box for some reason the print is not nice as you can see in first stage . I check again the bed leveling and z end point and i think it is OK . the material I use is HatchBox PLA and i set the extruder temp to be 205 Cel. degrees for first layer and 200 after
i attach 2 pictures
a) first stage
b) after print finish
The material I use is not very new(few month since start to use ) but i keep it in box with moisture dryer
Any idea ??
Doron
I just finish to update my m2 printer to hotend v4 and installed the metal holder for the extrude motor . and after long time ( I have to wait for parts to come ) i try to print a simple box for some reason the print is not nice as you can see in first stage . I check again the bed leveling and z end point and i think it is OK . the material I use is HatchBox PLA and i set the extruder temp to be 205 Cel. degrees for first layer and 200 after
i attach 2 pictures
a) first stage
b) after print finish
The material I use is not very new(few month since start to use ) but i keep it in box with moisture dryer
Any idea ??
Doron