Another question about homing all endstops

Ask the MakerGear community for assistance...
Post Reply
daveb
Posts: 22
Joined: Tue Nov 03, 2015 4:06 am

Another question about homing all endstops

Post by daveb » Wed Aug 16, 2017 6:23 pm

Here we go with another question. May be obvious to you folks, but I can not remember. How to I reset all the Axis Home's? I was trying with the Quickstart app, but they didn't save. Tried with S3D and no luck. I know it's just something I am not seeing.

User avatar
sthone
Posts: 897
Joined: Tue Jul 08, 2014 8:25 pm
Location: Connecticut
Contact:

Re: Another question about homing all endstops

Post by sthone » Wed Aug 16, 2017 10:02 pm

The home locations are all controlled by the actual end stop switches on the printer.

The only thing the quick start app does is set the offset into the firmware for the actual z-height. (well that and help you level the bed.)

In Octoprint hitting the Home button for X and Y movements should move the bed until it hits the end stops.

The Z home button will only home to the top on Rev. D (or older) M'2s.... if you click the home with a Rev E. it homes to the bottom because that's where the end stop is now.

What exactly are you trying to do?

-Steve
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com

Post Reply