Every print I make gets these little raised bumps.

Ask the MakerGear community for assistance...
Post Reply
Spencer
Posts: 64
Joined: Tue Feb 02, 2016 6:56 pm

Every print I make gets these little raised bumps.

Post by Spencer » Mon Nov 06, 2017 11:47 pm

https://imgur.com/a/wNUk9

I have a M2 Rev E. Every print gets these bumps in the same exact spot. Any ideas?
Top
Gwhite
Posts: 372
Joined: Tue Jul 11, 2017 3:38 pm

Re: Every print I make gets these little raised bumps.

Post by Gwhite » Tue Nov 07, 2017 2:19 am

They are typically called "zits". Simplify 3D has a very good troubleshooting guide. Here's the section on "blobs & zits":

https://www.simplify3d.com/support/prin ... s-and-zits
Top
Post Reply

Return to “Tech Support”