Hi-
I have been using my MakerGear for some time and recently experienced the part being printed to corner of bed (see below) even though in the Simplify3D preview all looked fine.
When it started printing it actually wanted to print even further off the bed and I hear a grinding noise for several seconds before it starts printing in the corner.
I tried re homing and cannot seem to correct the issue.
I feel like it is damaging the belts and don't know what to try next.
Regards,
Dave
Part offset from center of bed
Re: Part offset from center of bed
The M2 orients itself with 0,0 in the lower-left of the bed (about where your part is). Your plater in S3D shows it centered in the middle of the platform.
S3D has MakerGear M2 profiles -- use those.
S3D has MakerGear M2 profiles -- use those.
Custom 3D printing for you or your business -- quote [at] pingring.org
Re: Part offset from center of bed
Thank you Insta! I see that the GCode tab settings where wrong!