MG3 IDEX Duplication Mode - extruders hit eachother
Posted: Sun Jan 07, 2018 5:54 am
Hi Everyone,
I recently received my printer and have tried duplication mode. I have only had one successful attempt, where as in all the other prints (even the same ones) the extruders hit each other during priming? I set up the print on Simplify3D using the makergear provided FFF duplication mode file. I did adjust the temperatures and added a brim but I made sure the object was in the middle of the half sized base. Does any one know why this is happening?
Thanks in advanced!
I recently received my printer and have tried duplication mode. I have only had one successful attempt, where as in all the other prints (even the same ones) the extruders hit each other during priming? I set up the print on Simplify3D using the makergear provided FFF duplication mode file. I did adjust the temperatures and added a brim but I made sure the object was in the middle of the half sized base. Does any one know why this is happening?
Thanks in advanced!