Extruder and XYZ stepper mortes stooped working
Posted: Sat Jan 20, 2018 5:07 pm
Hi,
Last night I had a print fail due to the bed plate screw (back one) fall off. I stopped the print after hearing it from the other room it was still moving and "printing". I hit the power switch ASAP. Now after finding the 3 parts and reattaching them I went to turn it back on. The steppers will not move Via LCD (direct connection to MB), OctoPrint, or S3D. The hot ends do heat up and the MB does not seem to show any lights of an issue, and the Communication to the MB seems fine ( echos the temps). The steppers seem o move freely if engaged or not engaged.
I have -
- Powered if off fully
- Checked the fuse ( it looks and test out ok)
- Sent commands to it ( does not move)
- disabled or enabled, the steppers move freely with both
What am I missing?
Please and Thank you!
Last night I had a print fail due to the bed plate screw (back one) fall off. I stopped the print after hearing it from the other room it was still moving and "printing". I hit the power switch ASAP. Now after finding the 3 parts and reattaching them I went to turn it back on. The steppers will not move Via LCD (direct connection to MB), OctoPrint, or S3D. The hot ends do heat up and the MB does not seem to show any lights of an issue, and the Communication to the MB seems fine ( echos the temps). The steppers seem o move freely if engaged or not engaged.
I have -
- Powered if off fully
- Checked the fuse ( it looks and test out ok)
- Sent commands to it ( does not move)
- disabled or enabled, the steppers move freely with both
What am I missing?
Please and Thank you!