M2 Dual (24v Conv) extruders quit heating

Ask the MakerGear community for assistance...
Post Reply
protoJay
Posts: 1
Joined: Sat Feb 03, 2018 6:46 pm

M2 Dual (24v Conv) extruders quit heating

Post by protoJay » Sat Feb 03, 2018 7:02 pm

Our M2 with dual conversion setup has been flawless since day one. Has the single 24V power supply. Probably 500 hours of successful dual prints. Today the extruders simply won't heat up. The bed heats fine. Checked connections, all seem tight. Tried unplugging, etc. Using S3D....the communication box indicates communication is OK. Anyone have this issue? Fix?

jk42
Posts: 50
Joined: Mon Oct 09, 2017 5:19 pm

Re: M2 Dual (24v Conv) extruders quit heating

Post by jk42 » Mon Feb 05, 2018 7:44 pm

Please contact us at support@makergear.com
We would be happy to assist you with troubleshooting your issue!
~Jason from MakerGear

Post Reply