Hi guys
I try to print PLA on the MIC6 plate covered with PEI plate . till now with not great success ( the start print layer does not stick well ) .
To what temp. ( in C degrees ) do you heat the plate ?
Regards Doron
MIC 6 plate and PEI
Re: MIC 6 plate and PEI
Plate temperature depends on the PLA you are using. I use 45C-60C for the PLAs I print. More importantly is to ensure your bed is CLEAN; I usually wipe it with acetone or glass cleaner. Secondly, ensure you are 'squishing' your first layer enough. You may try turning your Z-axis knob one click closer.
Re: MIC 6 plate and PEI
If you bed height is correct and it's not sticking to PEI you can try scuffing the PEI surface slightly with steel wool to help with adhesion.
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com
See my projects at https://www.theneverendingprojectslist.com
Re: MIC 6 plate and PEI
Thanks for help .The bed was not very leveled
Doron
Doron