Ask the MakerGear community for assistance...
- Posts: 279
- Joined: Wed Jan 31, 2018 11:36 pm
sthone wrote: ↑
Fri May 18, 2018 2:37 pm
I'd be careful... I use cheap Logitech C270's and the one I ran inside an enclosure one time pretty much stopped working. It could be coincidence but I wouldn't try it with any camera that was expensive that's for sure.
Yes, I have a mount that uses a magnet to hold the cam to the Plexiglas on the inside so I can remove it if using filament that requires the enclosure to be closed... Just need to rethink the mount so it can be used on the outside if I so desire.