M2 octoprint on Pi what to buy

Ask the MakerGear community for assistance...
airscapes
Posts: 594
Joined: Wed Jan 31, 2018 11:36 pm

Re: M2 octoprint on Pi what to buy

Post by airscapes » Fri May 18, 2018 3:05 pm

sthone wrote:
Fri May 18, 2018 2:37 pm

I'd be careful... I use cheap Logitech C270's and the one I ran inside an enclosure one time pretty much stopped working. It could be coincidence but I wouldn't try it with any camera that was expensive that's for sure.
Yes, I have a mount that uses a magnet to hold the cam to the Plexiglas on the inside so I can remove it if using filament that requires the enclosure to be closed... Just need to rethink the mount so it can be used on the outside if I so desire.

Glas
Posts: 4
Joined: Tue Jan 17, 2017 7:24 pm

Re: M2 octoprint on Pi what to buy

Post by Glas » Tue Jun 19, 2018 12:19 am

I found this set of YouTube videos helpful in setting mine up.
https://m.youtube.com/watch?v=vKmLAnb4KrA

Post Reply