Page 3 of 3

Re: M2 octoprint on Pi what to buy

Posted: Fri May 18, 2018 3:05 pm
by airscapes
sthone wrote:
Fri May 18, 2018 2:37 pm

I'd be careful... I use cheap Logitech C270's and the one I ran inside an enclosure one time pretty much stopped working. It could be coincidence but I wouldn't try it with any camera that was expensive that's for sure.
Yes, I have a mount that uses a magnet to hold the cam to the Plexiglas on the inside so I can remove it if using filament that requires the enclosure to be closed... Just need to rethink the mount so it can be used on the outside if I so desire.

Re: M2 octoprint on Pi what to buy

Posted: Tue Jun 19, 2018 12:19 am
by Glas
I found this set of YouTube videos helpful in setting mine up.
https://m.youtube.com/watch?v=vKmLAnb4KrA