New M2 owner here. I tried searching for this problem, but could only see issues with curling off of the nozzle due to blockage, etc.
I have this weird curling going on as I'm laying down the 1st layer after the raft. This is a Hatchbox PLA dark wood filament. I'm printing at 220° nozzle and 70° bed temps and I never had this problem using the lighter color wood filament from Hatchbox.
Could anybody make a guess at what's happenening?
Sorry for the blurriness!
Ask the MakerGear community for assistance...
2 posts • Page 1 of 1