Curling off of Raft
Posted: Mon May 14, 2018 7:28 pm
Hi all,
New M2 owner here. I tried searching for this problem, but could only see issues with curling off of the nozzle due to blockage, etc.
I have this weird curling going on as I'm laying down the 1st layer after the raft. This is a Hatchbox PLA dark wood filament. I'm printing at 220° nozzle and 70° bed temps and I never had this problem using the lighter color wood filament from Hatchbox.
Could anybody make a guess at what's happenening?
..
Sorry for the blurriness!
thanks
Jim
New M2 owner here. I tried searching for this problem, but could only see issues with curling off of the nozzle due to blockage, etc.
I have this weird curling going on as I'm laying down the 1st layer after the raft. This is a Hatchbox PLA dark wood filament. I'm printing at 220° nozzle and 70° bed temps and I never had this problem using the lighter color wood filament from Hatchbox.
Could anybody make a guess at what's happenening?
..
Sorry for the blurriness!
thanks
Jim