Layers are shifting all over the place
Posted: Sun Jun 03, 2018 7:10 pm
I think she's getting to that point where she needs a major tune-up. I've had consistent prints for about 2 years with her making numerous props etc. Lately, on the last 2 test prints my calibration cubes come out perfect but the prints themselves seem completely out of wack.
I've checked the filament, no change there, same OD
Extrusion seems ok, but the X and Y Axis seems to shift from layer to layer. The belts seem tight enough but I'm not sure if I should attempt to tighten them myself.
any thoughts from folks?
I've checked the filament, no change there, same OD
Extrusion seems ok, but the X and Y Axis seems to shift from layer to layer. The belts seem tight enough but I'm not sure if I should attempt to tighten them myself.
any thoughts from folks?