What have I fried?

Ask the MakerGear community for assistance...
Pum
Posts: 10
Joined: Mon Sep 14, 2015 11:26 am

Re: What have I fried?

Post by Pum » Sun Sep 09, 2018 11:07 pm

So MakerGear tech support were super helpful as usual, and I was super stupid. Because I had the extruder all apart and was only focused on the extruder motor gear, I forgot the hotend has to be heated up above 170C before the firmware will let the extruder motor turn – doh! All working good now. Thanx to everyone that helped.

I now have a UK based spare RAMBo available to sell if any other UK M2 users needs one for much cheaper shipping.

Post Reply