Hello,
I saved a copy of your (MakerGear's) PLA simplify3D profile, and renamed into to something else to give me a good starting point for another material. All changed values stick in this new profile except for the extruder temp value, it always reverts back to 190! Any idea why? I can't seem to figure out how to change this and have it actually save and stick in the new copied profile.
changing extruder temps in official M3-ID .fff profile
Re: changing extruder temps in official M3-ID .fff profile
Did you try saving it as a new file?
Re: changing extruder temps in official M3-ID .fff profile
Yes I just tried saving it as new after I changed the temp to 230. when I open the newly saved profile its back to 190
Re: changing extruder temps in official M3-ID .fff profile
here is a download link to the file
https://drive.google.com/file/d/1ZhqVHx ... sp=sharing
if any one can actually get a temp. change to stick please tell me how! Thanks
https://drive.google.com/file/d/1ZhqVHx ... sp=sharing
if any one can actually get a temp. change to stick please tell me how! Thanks