As I am starting another print, I get this message: "Z Probe attempt has failed" and "Warning: [007]-[11] Probe Failure.
It seems my M3-ID can no longer calibrate. Does anyone know a solution?
Probe Failure
Re: Probe Failure
I would give MakerGear Tech support a call. They are there to help!
-
- Posts: 10
- Joined: Sat Jun 09, 2018 6:19 pm
Re: Probe Failure
I just resolved the same issue on my m3id. Turns out the cable plugged into the bl touch had bad crimps. if the wires are pulling away from the plug, push them back in.