Probe Failure

Ask the MakerGear community for assistance...
Post Reply
printer
Posts: 1
Joined: Sun Oct 21, 2018 4:21 am

Probe Failure

Post by printer » Sun Oct 21, 2018 4:24 am

As I am starting another print, I get this message: "Z Probe attempt has failed" and "Warning: [007]-[11] Probe Failure.

It seems my M3-ID can no longer calibrate. Does anyone know a solution?

airscapes
Posts: 594
Joined: Wed Jan 31, 2018 11:36 pm

Re: Probe Failure

Post by airscapes » Mon Oct 22, 2018 2:37 pm

I would give MakerGear Tech support a call. They are there to help!

macmccaskie
Posts: 10
Joined: Sat Jun 09, 2018 6:19 pm

Re: Probe Failure

Post by macmccaskie » Sat Nov 03, 2018 4:56 pm

I just resolved the same issue on my m3id. Turns out the cable plugged into the bl touch had bad crimps. if the wires are pulling away from the plug, push them back in.

Post Reply