Feed motor

Ask the MakerGear community for assistance...
Post Reply
turtleman
Posts: 18
Joined: Fri Oct 19, 2018 12:57 am

Feed motor

Post by turtleman » Sat Dec 01, 2018 1:56 am

I was changing filament and when I tried to start it, it would not feed. I found a piece of the old filament and then tried it again. The motor would not run. Is their a fuse somewhere that I need to change?

Thanks

User avatar
ednisley
Posts: 1040
Joined: Fri Apr 11, 2014 5:34 pm
Location: Halfway up the Hudson
Contact:

Re: Feed motor

Post by ednisley » Sat Dec 01, 2018 2:25 pm

turtleman wrote:
Sat Dec 01, 2018 1:56 am
Is their a fuse somewhere that I need to change?
The firmware won't drive the motor unless the hot end is at the proper temperature.

Check that first …

turtleman
Posts: 18
Joined: Fri Oct 19, 2018 12:57 am

Re: Feed motor

Post by turtleman » Sun Dec 02, 2018 2:47 am

Thanks, I forgot about that, its working fine now

Post Reply