Fan doesn't work below ~92%

Ask the MakerGear community for assistance...
Post Reply
dcastor
Posts: 2
Joined: Sun Oct 23, 2016 10:54 pm

Fan doesn't work below ~92%

Post by dcastor » Sat Dec 15, 2018 4:17 pm

I bought a used M2, it's got a single V4 hot end and serial number 31115783. Since I got it I the 50mm fan seems to only run if it's set to about 92% or higher, even if it's coming down from 100% it will shut off with any percentage below that. Just got a new fan from Makergear, no change.

The fan I took off was a 24V and the fan I got from Makergear was the exact same 24V.

What am I doing wrong?

Dave

Post Reply