M3 Dual Extruder doesn't boot anymore
Posted: Sun Feb 03, 2019 7:14 pm
Hello,
I was printing some mode, but things were going wrong...
I decided to check the bed level, and reset the main M3 board.
After that, the symptoms are:
- at boot, the M3 emits only two notes instead of the whole boot set of notes.
- the green led lights on,
- the fan does not start,
- the Octoprint is unable to connect to the M3.
A great thanks for any hint.
Sincerely Yours
H. Delebecque
I was printing some mode, but things were going wrong...
I decided to check the bed level, and reset the main M3 board.
After that, the symptoms are:
- at boot, the M3 emits only two notes instead of the whole boot set of notes.
- the green led lights on,
- the fan does not start,
- the Octoprint is unable to connect to the M3.
A great thanks for any hint.
Sincerely Yours
H. Delebecque