M3 Dual Extruder doesn't boot anymore

Ask the MakerGear community for assistance...
Post Reply
hdlbq
Posts: 9
Joined: Sun Feb 03, 2019 7:05 pm

M3 Dual Extruder doesn't boot anymore

Post by hdlbq » Sun Feb 03, 2019 7:14 pm

Hello,
I was printing some mode, but things were going wrong...
I decided to check the bed level, and reset the main M3 board.
After that, the symptoms are:
- at boot, the M3 emits only two notes instead of the whole boot set of notes.
- the green led lights on,
- the fan does not start,
- the Octoprint is unable to connect to the M3.

A great thanks for any hint.
Sincerely Yours
H. Delebecque

airscapes
Posts: 594
Joined: Wed Jan 31, 2018 11:36 pm

Re: M3 Dual Extruder doesn't boot anymore

Post by airscapes » Mon Feb 04, 2019 3:02 pm

You may want to just Call Tech support, may get your going a Lot faster, this forum is not very active and tech support does not seem to monitor it.

hdlbq
Posts: 9
Joined: Sun Feb 03, 2019 7:05 pm

Re: M3 Dual Extruder doesn't boot anymore

Post by hdlbq » Mon Feb 04, 2019 10:32 pm

Hello,
thanks for your suggestion.
They answer with a piece of adive that solves the problem
Best regards

Post Reply