Tips for Replacing Filament Drive Gearbox Pinion?

Ask the MakerGear community for assistance...
Post Reply
Gwhite
Posts: 372
Joined: Tue Jul 11, 2017 3:38 pm

Tips for Replacing Filament Drive Gearbox Pinion?

Post by Gwhite » Wed Feb 13, 2019 2:46 am

My pinion gear is getting a bit worn, and I have a replacement. I've seen various comments that they may be installed with an adhesive. At a minimum it's probably going to require a tiny gear puller, maybe along with some heat.

Any recommendations on a puller the right size? If I need to apply heat, I've had good luck putting things under tension & then heating them with a soldering iron. Most bearing retainer/threadlocker compounds let go a a few hundred degrees F, which is easy for a soldering iron, a lot safer than a torch, and much more pinpoint than a heat gun.

Thanks!

Post Reply