now all the prints keep slowly shifting over to the right. It was printing fine before. This happens with
anything I try to print.
The objects render correctly but do not print correctly. See images below.
I have tried with Pronterface/Slic3r on both Windows and Linux (multiple versions as well).
They all give the same results. I am using the M2 default slicer configs from the wiki.
I am running the latest version of the firmware for my printer.
M2 with the following config
- Sliver Z-axis motor
- 24volt PS
- Z-min top
- v3b hot-end
Code: Select all
Connecting... start Printer is now online. echo:Marlin: 1.0.0 RC2 for MakerGear M2 echo: Last Updated: 2012-05-30 | Author: johnny echo: Free Memory: 4775 PlannerBufferBytes: 1232 echo:Using Default settings: echo:Steps per unit: echo: M92 X88.88 Y88.88 Z400.00 E471.50 echo:Maximum feedrates (mm/s): echo: M203 X500.00 Y500.00 Z250.00 E200000.00 echo:Maximum Acceleration (mm/s2): echo: M201 X9000 Y9000 Z30 E10000 echo:Acceleration: S=acceleration, T=retract acceleration echo: M204 S3000.00 T3000.00 echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum xY jerk (mm/s), Z=maximum Z jerk (mm/s) echo: M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00 echo:PID settings: echo: M301 P25.89 I1.94 D86.53 echo:SD card ok