Issue printing any object on my M2
Posted: Sat Mar 16, 2019 7:47 pm
Any idea what might be causing this? I fired up the printer after about two months of inactivity and
now all the prints keep slowly shifting over to the right. It was printing fine before. This happens with
anything I try to print.
The objects render correctly but do not print correctly. See images below.
I have tried with Pronterface/Slic3r on both Windows and Linux (multiple versions as well).
They all give the same results. I am using the M2 default slicer configs from the wiki.
I am running the latest version of the firmware for my printer.
M2 with the following config
Images:
https://imgur.com/1KRCRV7
https://imgur.com/vmKD5tE
now all the prints keep slowly shifting over to the right. It was printing fine before. This happens with
anything I try to print.
The objects render correctly but do not print correctly. See images below.
I have tried with Pronterface/Slic3r on both Windows and Linux (multiple versions as well).
They all give the same results. I am using the M2 default slicer configs from the wiki.
I am running the latest version of the firmware for my printer.
M2 with the following config
- Sliver Z-axis motor
- 24volt PS
- Z-min top
- v3b hot-end
Code: Select all
Connecting...
start
Printer is now online.
echo:Marlin: 1.0.0 RC2 for MakerGear M2
echo: Last Updated: 2012-05-30 | Author: johnny
echo: Free Memory: 4775 PlannerBufferBytes: 1232
echo:Using Default settings:
echo:Steps per unit:
echo: M92 X88.88 Y88.88 Z400.00 E471.50
echo:Maximum feedrates (mm/s):
echo: M203 X500.00 Y500.00 Z250.00 E200000.00
echo:Maximum Acceleration (mm/s2):
echo: M201 X9000 Y9000 Z30 E10000
echo:Acceleration: S=acceleration, T=retract acceleration
echo: M204 S3000.00 T3000.00
echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum xY jerk (mm/s), Z=maximum Z jerk (mm/s)
echo: M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00
echo:PID settings:
echo: M301 P25.89 I1.94 D86.53
echo:SD card ok
https://imgur.com/1KRCRV7
https://imgur.com/vmKD5tE