Re: strange print
Posted: Sat Aug 17, 2019 2:51 pm
The default PLA setting in S3D should work for HatchBox. It's pretty much bog standard PLA.
I'd start with the S3D default PLA profile, and see if you can get a good extrusion multiplier setting. Once you can get a clean cube, then (and only then) move on to your model.
The mess on the bottom looks like you may not have enough lower layers. The wavey stuff looks like "ringing". For a really good general trouble shooting guide, check out S3D's:
https://www.simplify3d.com/support/prin ... eshooting/
I'd start with the S3D default PLA profile, and see if you can get a good extrusion multiplier setting. Once you can get a clean cube, then (and only then) move on to your model.
The mess on the bottom looks like you may not have enough lower layers. The wavey stuff looks like "ringing". For a really good general trouble shooting guide, check out S3D's:
https://www.simplify3d.com/support/prin ... eshooting/