Slight problems
Posted: Fri Jun 20, 2014 9:22 pm
I'm having trouble with the following items:
Hot end doesn't raise above 208.1C and fluctuates per the image below The extruder seems to keep extruding even when nothing is happening
Hot end keeps plugging up (I have 2 and both are doing the same heat and extruding things.
I think I loaded the right fireware update but I'm not sure what to do from here. It was working fine and I got maybe 30 hours on it total but now it is wonky... I'm guessing it is firmware related? (Purchased after April / 1/16 step)
Hot end doesn't raise above 208.1C and fluctuates per the image below The extruder seems to keep extruding even when nothing is happening
Hot end keeps plugging up (I have 2 and both are doing the same heat and extruding things.
I think I loaded the right fireware update but I'm not sure what to do from here. It was working fine and I got maybe 30 hours on it total but now it is wonky... I'm guessing it is firmware related? (Purchased after April / 1/16 step)