rev e dual z axis inverted
Posted: Mon Oct 14, 2019 1:53 am
Guys,
I just upgraded my M2 dual to the 4 screw spider bed. I followed all the instructions I could find. Upgraded the firmware to rev e (M2E-Production-SnNRd-V101 - Dual) and ran the calibration tool. The first thing I noticed was that the Z travel in the calibration tool is reversed, meaning when I click the down arrow, the bed travels up. This is happening in Simplify 3d as well. The bed never travels up, but I can hear it bottoming out while trying to go down at the beginning of the print.
Also - I have the Geetech LCD.
What did I miss?
I just upgraded my M2 dual to the 4 screw spider bed. I followed all the instructions I could find. Upgraded the firmware to rev e (M2E-Production-SnNRd-V101 - Dual) and ran the calibration tool. The first thing I noticed was that the Z travel in the calibration tool is reversed, meaning when I click the down arrow, the bed travels up. This is happening in Simplify 3d as well. The bed never travels up, but I can hear it bottoming out while trying to go down at the beginning of the print.
Also - I have the Geetech LCD.
What did I miss?