Initial height with multiple hot ends
Posted: Wed Feb 19, 2020 1:39 pm
I have 2 hot ends, one with a 0.50 nozzle and one with a 0.35 nozzle. I change them a couple times a week..... 0.35 for PLA, 0.50 for TPU.
I REALLY don't want to go through the whole bed leveling ordeal every time lol. The bed is level.
What I want to do is just issue a command that will drive the M2 to the center of the bed at it's zero height, slip in the feeler gage, and adjust the nozzle by loosening the SHCS on the hot end and letting gravity drop it down to the feeler gage. Tighten, and Bob's you mother's brother.....
Same thing if I'm using painter's tape or not...it's kinda thick.
TIA
I REALLY don't want to go through the whole bed leveling ordeal every time lol. The bed is level.
What I want to do is just issue a command that will drive the M2 to the center of the bed at it's zero height, slip in the feeler gage, and adjust the nozzle by loosening the SHCS on the hot end and letting gravity drop it down to the feeler gage. Tighten, and Bob's you mother's brother.....
Same thing if I'm using painter's tape or not...it's kinda thick.
TIA