Changing block heater from 0 to 1 on RAMBO
Posted: Wed Feb 26, 2020 8:19 pm
I'm having a problem- every time I activate my extruder heater, my USB disconnects- weird I know.
I've connected a heater directly to the screw terminal plug on HEAT0 and still get the same problem, so I believe its in the board and not the wiring.
To troubleshoot I'm going to move the heater to the HEAT1 position on the board as in the linked photo. I also need to change the thermistor so it will know its monitoring the correct heater.
Are these settings in the marlin firmware? I'm not finding them in Configuration.h? Maybe I'm just overlooking them...
Thanks for any help.
https://reprap.org/mediawiki/images/b/b ... n-main.jpg
I've connected a heater directly to the screw terminal plug on HEAT0 and still get the same problem, so I believe its in the board and not the wiring.
To troubleshoot I'm going to move the heater to the HEAT1 position on the board as in the linked photo. I also need to change the thermistor so it will know its monitoring the correct heater.
Are these settings in the marlin firmware? I'm not finding them in Configuration.h? Maybe I'm just overlooking them...
Thanks for any help.
https://reprap.org/mediawiki/images/b/b ... n-main.jpg