Lots of play on M2 legacy build plate- bad carriage block?
Posted: Tue Jun 16, 2020 9:07 pm
I have a M2 with lots of hours on it. The bed has a good ~1mm of play at the corners, and I'm getting inconsistencies on the walls of my prints.
The black bed holder is firmly screwed into the silver support underneath, the silver support is firmly screwed to the block, and the belts are properly tensioned, so it seems like the carriage block is the source of the slack. Does this seem logical?
The black bed holder is firmly screwed into the silver support underneath, the silver support is firmly screwed to the block, and the belts are properly tensioned, so it seems like the carriage block is the source of the slack. Does this seem logical?