M3-ID Octoprint 'Still stabilizing'
Posted: Sat Jun 27, 2020 10:40 am
Hi there, I'm very new to this forum and just getting to grips with my M3-ID. up until now, I have had no real issues but I recently uploaded a simple model with Gcode created with Simplify 3D. I used an existing stl and scaled by 150% in S3D and uploaded to Octoprint.
When I begin printing this part, the state shows 'Still stabilizing...' (with a red dot). When I hover over the red dot, the following message appears: 'Based on linear approximation (very low accuracy, especially at the beginning of the print)'
The print is extremely slow and states 16 hours for a 2.6MB file.
Any advice would be amazing.
Thanks in advance
When I begin printing this part, the state shows 'Still stabilizing...' (with a red dot). When I hover over the red dot, the following message appears: 'Based on linear approximation (very low accuracy, especially at the beginning of the print)'
The print is extremely slow and states 16 hours for a 2.6MB file.
Any advice would be amazing.
Thanks in advance