Power to heated bed M2
Posted: Sat Dec 12, 2020 4:30 pm
Hi
Saturday nice day so I turn on my M2 printer . Heated bed temp=0 . Check wires OK . Check PS output 3 output =24v . Check on the Arduino TB
no power on HBP connector .Try Power UP again the some result . Heater and Fan board connectors got 24v .try to check 3 fuses they are fine .
Try to unplug the HBP from connector and check directly or the board connector but the some result . Any idea ( problem in Arudino board ?)
Regards Doron
Saturday nice day so I turn on my M2 printer . Heated bed temp=0 . Check wires OK . Check PS output 3 output =24v . Check on the Arduino TB
no power on HBP connector .Try Power UP again the some result . Heater and Fan board connectors got 24v .try to check 3 fuses they are fine .
Try to unplug the HBP from connector and check directly or the board connector but the some result . Any idea ( problem in Arudino board ?)
Regards Doron