I have tried to generate gcode from simplify3d but i have some problems. I started out by getting the profiles for the printer, i'm currently using the MakerGear M3 Independent Dual profile.
My problem is that the print starts before the extruder is at set point

My first problem was that i select extruder 1 but but only set a setpoint for extruder 0 in simplify3d. After fixing that, i now have a setup where in simplify3d extruder 0 is at setup 215c and bed is 70c for PLA printing.
I then generate gcode and load it onto the printer. The print startes with heating up the bed and when at 70c the print starts! The extruder is not at set point.
Has any one had this getting started issue?