I just tried to print a small 20mm calibration cube using my brand-new M3 ID, using my licensed copy of S3D and the M3 ID profiles from Makergear. I uploaded the gcode the Octoprint server and started the print.
At first the printer didn't want to start at all, and eventually produced a 'probe failure' error. I cancelled and restarted the print, and this time the left (unused) extruder probed the print bed as if it were going to do the print, instead of the right one. After probing the bed, the two extruder assemblies collided with each other (not sure which collided with which) and made a lot of noise. Then I got a 'cold extrusion prevented' error, so of course I quickly cancelled the print (again!)
WTF?? This was a very simple model, using the Makergear supplied profile, so now I'm not at all sure what's going on. Any pointers or information would be appreciated.
Need some assistance getting started...post here...
1 post • Page 1 of 1