How to stop the heating bed at s3d
How to stop the heating bed at s3d
Hi i want to use blue tape , but dont know how to stop the bed from heating
Re: How to stop the heating bed at s3d
When you run a print, the temperatures are baked into the gcode file when you prepare to print. Edit process settings, temperature tab, then click on Heated Bed. Remove all the setpoints.
Re: How to stop the heating bed at s3d
i tried and it says " each temperature is required to have at least one poit definition"
Re: How to stop the heating bed at s3d
ok so i have to create a new layer set point instead of saying 1 60 , create one that says 1 0 ?
Re: How to stop the heating bed at s3d
Hm, never really noticed that before. Maybe it's new. Or maybe I just never tried it.
You can remove the Heated Bed controller entirely, or you can set it to a value below room temperature. 0 should work, if your room temp is above that...
You can remove the Heated Bed controller entirely, or you can set it to a value below room temperature. 0 should work, if your room temp is above that...
Re: How to stop the heating bed at s3d
ok i set the set point 1 0, and it worked