How To: Guide to Getting Started (with Troubleshooting Tips)

Need some assistance getting started...post here...
jsc
Posts: 1864
Joined: Thu Apr 10, 2014 4:00 am

Re: How To: Guide to Getting Started (with Troubleshooting T

Post by jsc » Mon Mar 28, 2016 5:26 pm

Follow the calibration instructions in order: single perimeter cube, measure width, set extrusion; second single perimeter cube, measure height, set z-offset. Third perimeter cube with solid infill if you like to check that it's not getting overfilled.

Post Reply