What a Beast!

Need some assistance getting started...post here...
Post Reply
User avatar
Posts: 43
Joined: Thu May 05, 2016 4:20 am
Location: Springfield, Illinois

What a Beast!

Post by tks546 » Tue May 10, 2016 7:23 pm

Hi All,

I just received a new M2 and dual extruder kit, I'm amazed by the solid build of this machine.
This is my second printer the first was a delta kit that required assembly down to every nut and bolt.
The whole printer weighs about the same as the M2's power supply :D
The kit was a good learning experience and after lots of trial and error I'm able to make pretty nice prints with it.
I can't wait to see what the M2 can do!

I plan on waiting to install the second extruder until I am completely familiar with the M2.


User avatar
Posts: 3144
Joined: Wed Jan 21, 2015 1:36 am

Re: What a Beast!

Post by Jules » Wed May 11, 2016 4:14 am

It is, isn't it? Prints like a beast too!

Welcome to the group! :D

Post Reply