What a Beast!
Posted: Tue May 10, 2016 7:23 pm
Hi All,
I just received a new M2 and dual extruder kit, I'm amazed by the solid build of this machine.
This is my second printer the first was a delta kit that required assembly down to every nut and bolt.
The whole printer weighs about the same as the M2's power supply
The kit was a good learning experience and after lots of trial and error I'm able to make pretty nice prints with it.
I can't wait to see what the M2 can do!
I plan on waiting to install the second extruder until I am completely familiar with the M2.
-Tom
I just received a new M2 and dual extruder kit, I'm amazed by the solid build of this machine.
This is my second printer the first was a delta kit that required assembly down to every nut and bolt.
The whole printer weighs about the same as the M2's power supply
The kit was a good learning experience and after lots of trial and error I'm able to make pretty nice prints with it.
I can't wait to see what the M2 can do!
I plan on waiting to install the second extruder until I am completely familiar with the M2.
-Tom