How do I print
Posted: Sat May 21, 2016 12:45 am
I just received my MakerGear. Set everything up - no problem. Leveled bed - ok. Test print - OK
Now how do I print? I am using Simplify3D. I am connected. The bed temp is 70ºC. with a red light in the Settings panel lit. The extruder is not lit. It's temp is 25ºC. g-code says m:104 invalid extruder
Any help out there?
Scott
Now how do I print? I am using Simplify3D. I am connected. The bed temp is 70ºC. with a red light in the Settings panel lit. The extruder is not lit. It's temp is 25ºC. g-code says m:104 invalid extruder
Any help out there?
Scott