Running ABS for thee first time
Posted: Tue Jun 21, 2016 5:57 pm
Hello,
I'm new on the forums and I need some help (obviously ). Anyways, I've had my Makergear M2 for about 2-3 years and I love it. When I purchased the Makergear, I bought 3 spools of ABS and 5 spools of PLA and I've finally run out of PLA material. I know thee bed needs to be heated, so I went into the control panel and set thee bed and extruder temperature. The Extruder temperate is sitting at 250 Celsius actual temperature and the set temperature is 250 Celsius. The problem I'm having currently is I set my bed to 105 Celsius, but it is still set to the ambient temperature, which is 25 Celsius. I looked over all the wires and they look good. Under my communications, the bed itself isn't even going over 25.0 Celsius. Please help. Thank you so much.
I'm new on the forums and I need some help (obviously ). Anyways, I've had my Makergear M2 for about 2-3 years and I love it. When I purchased the Makergear, I bought 3 spools of ABS and 5 spools of PLA and I've finally run out of PLA material. I know thee bed needs to be heated, so I went into the control panel and set thee bed and extruder temperature. The Extruder temperate is sitting at 250 Celsius actual temperature and the set temperature is 250 Celsius. The problem I'm having currently is I set my bed to 105 Celsius, but it is still set to the ambient temperature, which is 25 Celsius. I looked over all the wires and they look good. Under my communications, the bed itself isn't even going over 25.0 Celsius. Please help. Thank you so much.