Quick Start - 2mm hex wrench step not available?
Posted: Sun Jun 26, 2016 4:59 am
Hello,
I just received my M2 Rev.E and I am really pleased with it so far.
I ran into some trouble doing through the Quick Start App tough.
First time I did all the steps, when the printer started, the nozzle was too low and crashed into the plate after it purged some filament.
Second time I ran the Quick Start, the nozzle was about .75'' too high.
So I decided to run the Quick Start App, close it after calibration, and rerun it. I did this process about 4 times. The last time I did that process, I received a new message from the software telling me that my printer was leveled sucessfully. This was the first time I received that message: all previous calibrations were followed by the first print steps. This indicates me that the Quick Start App is indeed an iterative process, as mentionned by an other member of the forum. The itearations are just not yet included within the software.
What troubles me tough is that I never received a message indicating that I should use the 2mm hex wrench to level the bed.
Should I worry about it? I assume I might have to use that step of calibration sooner or later, but I have no way of getting to it as of now.
Thanks!
I just received my M2 Rev.E and I am really pleased with it so far.
I ran into some trouble doing through the Quick Start App tough.
First time I did all the steps, when the printer started, the nozzle was too low and crashed into the plate after it purged some filament.
Second time I ran the Quick Start, the nozzle was about .75'' too high.
So I decided to run the Quick Start App, close it after calibration, and rerun it. I did this process about 4 times. The last time I did that process, I received a new message from the software telling me that my printer was leveled sucessfully. This was the first time I received that message: all previous calibrations were followed by the first print steps. This indicates me that the Quick Start App is indeed an iterative process, as mentionned by an other member of the forum. The itearations are just not yet included within the software.
What troubles me tough is that I never received a message indicating that I should use the 2mm hex wrench to level the bed.
Should I worry about it? I assume I might have to use that step of calibration sooner or later, but I have no way of getting to it as of now.
Thanks!