couple of questions about new M2

Need some assistance getting started...post here...
Post Reply
theboz1419
Posts: 94
Joined: Sun Jul 17, 2016 1:54 am
Location: Puyallup, WA

couple of questions about new M2

Post by theboz1419 » Sun Jul 17, 2016 2:02 am

Just received my new M2 rev.3 and seem to be missing my feeler gauge. what metric size do I need to get? Also, I'm curious about the filament, I have been working with plastics for close to 20 years, mainly sheet Hips, PET, APET, RPET, PP, HDPE, ect.... My question is, is it normal for PLA to break so easy. My roll I received from Makergear, has been breaking constantly. Its almost like spaghetti, in that it breaks very easy when it is getting unwound from the spool.

Edit....after recieving emails from Makergear, I believe this company knows how to treat its customers, they will replace the brittle roll by sending me two rolls, very nice of them. I also found where I misplaced the .002 guage along with the extra clips, lol.
Builder of custom wifi BBQ temperature controllers

Post Reply