Fan wiring

Need some assistance getting started...post here...
Post Reply
9alfred99
Posts: 13
Joined: Wed Sep 14, 2016 6:29 pm

Fan wiring

Post by 9alfred99 » Fri Oct 07, 2016 2:57 am

I have a question about fan wiring. I have a used Makergear M2, several years old, Rambo 1.3L and the all the wiring is individual, no harness.

I am running off of 12v and I am confused about which fan goes where. There is a extruder 0/Fan 0, Extruder 1/Fan 1 and a Fan 2.
I found an online manual that states M106 command controls Fan 0 which is the 50mm bed fan and M108 command controls Fan 1 which is the extruder and electronics fan Forget the electronics fan part right now.

So according to this, Fan 0 next to extruder 0 controls the bed fan and Fan 1 next to extruder 1 controls extruder 0 fan.

Is that correct?

tj

User avatar
Jules
Posts: 3150
Joined: Wed Jan 21, 2015 1:36 am

Re: Fan wiring

Post by Jules » Fri Oct 07, 2016 5:08 am

Correct. The larger bed fan is Fan 0. The Extruder Fan is Fan 1.

Post Reply