Fan wiring
Posted: Fri Oct 07, 2016 2:57 am
I have a question about fan wiring. I have a used Makergear M2, several years old, Rambo 1.3L and the all the wiring is individual, no harness.
I am running off of 12v and I am confused about which fan goes where. There is a extruder 0/Fan 0, Extruder 1/Fan 1 and a Fan 2.
I found an online manual that states M106 command controls Fan 0 which is the 50mm bed fan and M108 command controls Fan 1 which is the extruder and electronics fan Forget the electronics fan part right now.
So according to this, Fan 0 next to extruder 0 controls the bed fan and Fan 1 next to extruder 1 controls extruder 0 fan.
Is that correct?
tj
I am running off of 12v and I am confused about which fan goes where. There is a extruder 0/Fan 0, Extruder 1/Fan 1 and a Fan 2.
I found an online manual that states M106 command controls Fan 0 which is the 50mm bed fan and M108 command controls Fan 1 which is the extruder and electronics fan Forget the electronics fan part right now.
So according to this, Fan 0 next to extruder 0 controls the bed fan and Fan 1 next to extruder 1 controls extruder 0 fan.
Is that correct?
tj