Pronterface vs Simplify 3D?
Posted: Mon Jul 17, 2017 2:19 am
I have just assembled an M2 kit with the LCD controller. I've gone through the initial setup, calibration & test print without a hitch. Thge next step is to get a slicer, and i've decided to splurge on Simplify 3D.
I know Pronterface and Simplify 3D are very different programs, but if I need to do something like run the extruder in reverse to change filaments, can I do that entirely through Simplify 3D, or do I need a control package like Pronterface as well? As best I can tell, I can't do it through the LCD interface.
Thanks!
I know Pronterface and Simplify 3D are very different programs, but if I need to do something like run the extruder in reverse to change filaments, can I do that entirely through Simplify 3D, or do I need a control package like Pronterface as well? As best I can tell, I can't do it through the LCD interface.
Thanks!