Z-stop vs 1st layer

Need some assistance getting started...post here...
Post Reply
kidC
Posts: 1
Joined: Fri Oct 20, 2017 5:31 am

Z-stop vs 1st layer

Post by kidC » Sat Nov 04, 2017 9:41 pm

Newbie here, with a couple of questions. After setting Z-stop to about .13mm (heated bed and plate), when printing the first layer the bed does not activate the z-stop. Therefore there is a larger gap than was set and not great adhesion. Also the perimeters always go down in 2 layers, does this effect layer height /adhesion?

jk42
Posts: 67
Joined: Mon Oct 09, 2017 5:19 pm

Re: Z-stop vs 1st layer

Post by jk42 » Mon Nov 06, 2017 7:18 pm

Please contact us at support@makergear.com. We would be more than happy to assist you with your issue!
~Jason from MakerGear

Post Reply