Z-stop vs 1st layer

Need some assistance getting started...post here...

Z-stop vs 1st layer

Postby kidC » Sat Nov 04, 2017 9:41 pm

Newbie here, with a couple of questions. After setting Z-stop to about .13mm (heated bed and plate), when printing the first layer the bed does not activate the z-stop. Therefore there is a larger gap than was set and not great adhesion. Also the perimeters always go down in 2 layers, does this effect layer height /adhesion?
kidC
 
Posts: 1
Joined: Fri Oct 20, 2017 5:31 am

Re: Z-stop vs 1st layer

Postby jk42 » Mon Nov 06, 2017 7:18 pm

Please contact us at support@makergear.com. We would be more than happy to assist you with your issue!
~Jason from MakerGear
jk42
 
Posts: 38
Joined: Mon Oct 09, 2017 5:19 pm


Return to Getting Started

Who is online

Users browsing this forum: No registered users and 3 guests