Page 1 of 1

Z-stop vs 1st layer

Posted: Sat Nov 04, 2017 9:41 pm
by kidC
Newbie here, with a couple of questions. After setting Z-stop to about .13mm (heated bed and plate), when printing the first layer the bed does not activate the z-stop. Therefore there is a larger gap than was set and not great adhesion. Also the perimeters always go down in 2 layers, does this effect layer height /adhesion?

Re: Z-stop vs 1st layer

Posted: Mon Nov 06, 2017 7:18 pm
by jk42
Please contact us at We would be more than happy to assist you with your issue!