(used) new makergear purchase

Need some assistance getting started...post here...
Post Reply
duggerinc
Posts: 1
Joined: Thu Jun 07, 2018 3:18 pm

(used) new makergear purchase

Post by duggerinc » Fri Jun 08, 2018 10:42 pm

Hello everyone, long story short I purchased a maker gear from a woman whose husband passed away. I got a fantastic deal on it but it has some problems, and i am not exactly sure which model I have purchased. it says makergear m2 on the rear with a serial number, dual extruders on it. tech support couldn't give me any info from the serial number so im turning to yall for help. its in bad shape and needs a severe cleaning and possibly a complete rebuild. there are loose screws everywhere. any easy ways to identify the revision #? plastic electronics box, old style bed leveler (3 point) zstop at the top..... anything helps. thanks in advance.

User avatar
insta
Posts: 2018
Joined: Tue Sep 16, 2014 3:59 am

Re: (used) new makergear purchase

Post by insta » Mon Jun 11, 2018 2:22 pm

If it's a dual V4 extruder (vs a custom one) with a 3-point spider and a top-homing setup, it's a prototype dual -- so Rev D, ~ ish.

I'd take the whole thing (carefully) apart, clean all the slides with WD40 / QTips over and over, and re-lube with sewing machine oil. Make sure the fans are clean and quiet, and wires are zip-tied in the proper areas when reassembling them.
Custom 3D printing for you or your business -- quote [at] pingring.org

User avatar
Tim
Posts: 1192
Joined: Thu Apr 10, 2014 2:19 pm
Location: Poolesville, Maryland
Contact:

Re: (used) new makergear purchase

Post by Tim » Thu Jun 14, 2018 2:23 am

I agree with insta, most likely a rev D model. To get the dual extruder on the M2 (assuming, as insta says, it's the standard MakerGear M2 dual extruder) requires the V4 upgrade and the 24V upgrade, so basically if the model was earlier than a rev D, it would pretty much have to have been upgraded to something that is essentially a rev D. On the other hand, there were relatively few people who went through with that extensive rebuild process, so most likely it's a stock rev D 24V with the dual extruder add-on. In which case you're probably in good shape and will only need to clean it up and tighten down the screws.

There are a number of us on the forum that have those models, so just ask away, and send photos if you still aren't sure and want someone to confirm it.

Post Reply